0i

Scaling magnification is commanded in other than 1 -999999. Correct the scaling magnification setting (G51 Pp or parameter 5411 or 5421).

G51 (Scaling ON) is commanded in the tool offset mode. Modify the program.

BP/S alarm occurs in the same number as the P/S alarm that occurs in
ordinary program edit. (070, 071, 072, 073, 074 085,086,087 etc.) It was attempted to select or delete in the background a program being
selected in the foreground. (Note)
Use background editing correctly.

An axis is selected in commanding by PMC axis control. Modify the program.

The total distribution amount of the CNC and PMC is too large during superimposed control of the extended functions for PMC axis control.

A move command of other axes was specified to the same block as M code related to spindle indexing. Modify the program.

A move command of other axes was specified to the same block as spindle indexing addresses C, H. Modify the program. In index table indexing. Another control axis was instructed together with the B axis. Modify the program. A move command of other axes was specified to the same block as spindle indexing addresses C, H. Modify the program.

The index table indexing positioning angle was instructed in other than an integral multiple of the value of the minimum angle. Modify the program.Without any spindle orientation an attempt was made for spindle indexing. Perform spindle orientation

Small section data is erroneous in external alarm message or external operator message. Check the PMC ladder diagram.

No alarm No. concerned exists in external alarm message clear. Check the PMC ladder diagram.