Fanuc

The memory area is insufficient. Delete any unnecessary programs, then retry.

The final move command in the blocks specified by P and Q of G70, G71, G72, and G73 ended with chamfering or corner R. Modify the program.

G70, G71, G72, or G73 command with address P and Q. Modify the program.

An unallowable G code was commanded between two blocks specified by address P in G71, G72, or G73. Modify the program.

1.) G00 or G01 is not commanded at the block with the sequence number which is specified by address P in G71, G72, or G73 command. 2.) Address Z(W) or X(U) was commanded in the block with a sequence number which is specified by address P in G71 or G72, respectively. Modify the program.

A target shape which cannot be made by monotonic machining was specified in a repetitive canned cycle (G71 or G72).

The sequence number specified by address P in G70, G71, G72, or G73 command cannot be searched. Modify the program.

1. The depth of cut in G71 or G72 is zero or negative value. 2. The repetitive count in G73 is zero or negative value. 3. the negative value is specified to i or k is zero in G74 or G75. 4. A value other than zero is specified to address U or W though i or k is zero in G74 or G75. 5. A negative value is specified to d, though the relief direction in G74 or G75 is determined. 6. Zero or a negative value is specified to the height of thread or depth of cut of first time in G76. 7. The specified minimum depth of cut in G76 is greater than the height of thread. 8. An unusable angle of tool tip is specified in G76. Modify the program.

Address P or Q is not specified in G70, G71, G72, or G73 command. Modify the program.

Commanded sequence number was not found in the sequence number search. Check the sequence number.