Fanuc

The READY and SEND signals are out of sync with each other between the CNC and laser controller, so that data cannot be sent.

With the YAG laser, the current data sent to the oscillator has exceeded the allowable level.

A data resend request from the laser controller is kept for more than 10 seconds.

With the YAG laser, an error has occurred during initial loading of laser machining data into the oscillator.

The READY signal is not returned from the laser controller

This alarm is issued if the laser gas supply pressure has decreased, while the tank supply pressure has not.

This alarm is issued if the specified degree of vacuum has not been reached within the predetermined time during evacuation of the mixer.

This alarm is issued if the power to the relay PCB in the mixer is under an abnormal condition.

This alarm is issued if the pressure in the mixer is too high (1 MPa).

Parameters No.15223, No. 15242, and No. 15243 have been changed.