Fanuc

In a shear proof (G86) command, the tool size (P) was set to zero, or the blanking length (I) was 1.5 times larger than the tool size (P) or less. Alternatively, I, J, or P was not specified.

In a grid (G78, G79) command, the number of holes (P, K) was set to zero or a negative value. Alternatively, I, J, K, or P was not specified.

In an arc (G77) command, the radius (I) or the number of holes (K) was set to zero or a negative value. Alternatively, I, J, K, or P was not specified.

In a line-at-angle (G76) command, the number of holes (K) was set to zero or a negative value. Alternatively, I, J, or K was not specified.

In a bolt hole circle (G26) command, the radius (I) was set to zero or a negative value, or the number of holes (K) was set to zero. Alternatively, I, J, or K was not specified.

A repositioning command was specified in the circular interpolation (G02, G03) mode.

The RUN-ON operation is performed while the shutter is open.

With the YAG laser, an output command is specified with no execution register number specified.

With the YAG laser, the power calculated from the data sent to the oscillator has exceeded the allowable level.

See the touch display of the oscillator for the YAG laser.