Fanuc

Even when an M code was encountered in automatic operation mode, the flexible synchronization mode signal was not driven on or off. Check the ladder and M codes.

The gear ratio is not set correctly. (This alarm is issued when flexible synchronization is turned on.)

The axis number of the synchronous master axis or slave axis is incorrect. (This alarm is issued when flexible synchronization is turned on.) Alternatively, the axis number of the slave axis is smaller than that of the master axis.

A floppy disk in the built-in Handy File cannot be written to. The floppy disk may be defective, or the head may be dirty. Alternatively, the Handy File is defective.

A floppy disk in the built-in Handy File cannot be read from. The floppy disk may be defective, or the head may be dirty. Alternatively, the Handy File is defective.

A communication error occurred during communication with the built-in Handy File.

There is not enough floppy disk space in the built-in Handy File.

The number of files exceeds the limit during communication with the built-in Handy File.

A floppy disk in the built-in Handy File is write protected.

There are duplicate file names in the built-in Handy File.