0/00/0-mate

The sequence number specified by address P in G70, G71, G72, or G73 command cannot be searched. Modify the program.

1. The depth of cut in G71 or G72 is zero or negative value. 2. The repetitive count in G73 is zero or negative value. 3. the negative value is specified to i or k is zero in G74 or G75. 4. A value other than zero is specified to address U or W though i or k is zero in G74 or G75. 5. A negative value is specified to d, though the relief direction in G74 or G75 is determined. 6. Zero or a negative value is specified to the height of thread or depth of cut of first time in G76. 7. The specified minimum depth of cut in G76 is greater than the height of thread. 8. An unusable angle of tool tip is specified in G76. Modify the program.

Address P or Q is not specified in G70, G71, G72, or G73 command. Modify the program.

Commanded sequence number was not found in the sequence number search. Check the sequence number.

In an external program number search, a specified program number was not found. Otherwise, a program specified for searching is being edited in background processing. Check the program number and external signal. Or discontinue the background editing.

In a arbitrary angle chamfering or corner R cutting block, a specified axis is not in the selected plane. Correct the program. Block end point is not found in direct dimension drawing programming.

Block end point is not calculated correctly in direct dimension drawing programming.

Neither the end point nor angle is specified in the command for the block next to that for which only the angle is specified (A). In the chamfering command, I(K) is commanded for the X(Z) axis.

In the arbitrary angle chamfering or corner R block, the move distance is less than chamfer or corner R amount.

A block in which chamfering in the specified angle or the corner R was specified includes a taper command. Modify the program.