0/00/0-mate

The left side of substitution statement is a variable whose substitution is inhibited. Modify the program.

A value not defined as a variable number is designated in the custom macro or in high-speed cycle machining. The header contents are improper. This alarm is given in the following cases: High speed cycle machining 1. The header corresponding to the specified machining cycle number called is not found. 2. The cycle connection data value is out of the allowable range (0 -999). 3. The number of data in the header is out of the allowable range (0 -32767). 4. The start data variable number of executable format data is out of the allowable range (#20000 -#85535). 5. The last storing data variable number of executable format data is out of the allowable range (#85535). 6. The storing start data variable number of executable format data is overlapped with the variable number used in the header. Modify the program.

There is an error in the formats. Modify the program.

A function which cannot be used in custom macro is commanded. Modify the program.

Division by zero was specified. (including tan 90?) Modify the program.

The result of calculation turns out to be invalid, an alarm No.111 is issued. --1047 to -10--29,0,10--29 to 1047 Modify the program.

The absolute value of fixed decimal point display data exceeds the allowable range. Modify the program.

The power turned off while rewriting the memory by program edit operation. If this alarm has occurred, press Reset while pressing Program key, and only the program being edited will be deleted. Register the deleted program.

On the PARAMETER (SETTING) screen, PWE (parameter writing enabled) is set to 1. Set it to 0, then reset the system.

After completion of search in program restart, a move command is given with MDI. Move axis before a move command or don