16/18/21

The P value specifying the offset number of a fixture offset is too large. Correct the program.

A fixture offset parameter (No. 7580 to 7588) is illegal. Correct the parameter.

One of the following command conditions was present during flexible synchronization or when flexible synchronization was turned on: 1. The synchronous master axis or slave axis is the EGB axis. 2. The synchronous master axis or slave axis is the chopping axis. 3. In reference position return mode

Even when an M code was encountered in automatic operation mode, the flexible synchronization mode signal was not driven on or off. Check the ladder and M codes.

The gear ratio is not set correctly. (This alarm is issued when flexible synchronization is turned on.)

The axis number of the synchronous master axis or slave axis is incorrect. (This alarm is issued when flexible synchronization is turned on.) Alternatively, the axis number of the slave axis is smaller than that of the master axis.

A floppy disk in the built-in Handy File cannot be written to. The floppy disk may be defective, or the head may be dirty. Alternatively, the Handy File is defective.

A floppy disk in the built-in Handy File cannot be read from. The floppy disk may be defective, or the head may be dirty. Alternatively, the Handy File is defective.

A communication error occurred during communication with the built-in Handy File.

There is not enough floppy disk space in the built-in Handy File.