16i/18i/21i

In setting an offset amount by G10, the offset number following address P was excessive or it was not specified. Modify the program.

The offset number specified by D/H code for tool length offset or cutter compensation is too large. Alternatively, the number of an additional work piece coordinate system specified with the P code is too large. Modify the program. The offset number in T function specified for tool offset is tool large

The offset values specified by T code is too large or the offset values specified by H code is too large.

In the plane selection command, two or more axes in the same direction are commanded. Modify the program.

No axis is specified in G43 and G44 blocks for the tool length offset type C.Offset is not canceled but another axis is offset for the tool length offset type C. Modify the program.

F0 (fast feed) was instructed by F1 -digit column feed in circular interpolation. Modify the program.

In circular interpolation by radius designation, negative value was commanded for address R. Modify the program.

The command for circular interpolation lacks arc radius R or coordinate I, J, or K of the distance between the start point to the center of the arc.

An axis not included in the selected plane (by using G17, G18, G19) was commanded in circular interpolation. Modify the program.

In circular interpolation (G02 or G03), difference of the distance between the start point and the center of an arc and that between the end point and the center of the arc exceeded the value specified in parameter No. 3410