16i/18i/21i

H code and automatic tool compensation (G37) were specified in the same block. (Automatic tool length measurement function) Modify the program. T code and automatic tool compensation (G36, G37) were specified in the same block. (Automatic tool compensation function) Modify the program.

Tool length automatic measurement (G37) was specified without a Hcode. (Automatic tool length measurement function). Automatic tool compensation (G36, G37) was specified without a Tcode. (Automatic tool compensation function) Modify the program.

In the automatic tool length measurement function (G37), the measurement position reach signal (XAE, YAE, or ZAE) is not turned on within an area specified in parameter 6254 6255. In the automatic tool compensation function (G36, G37), the measurement position reach signal (XAE or ZAE) is not turned on within an area specified in parameter 6254 . This is due to a setting or operator error.

In memory or program collation, a program in memory does not agree with that read from an external I/O device. Check both the programs in memory and those from the external device.

A program number or a sequence number which was specified by address P in the block which includes an M98, M99, M65 or G66 was not found. The sequence number specified by a GOTO statement was not found. Otherwise, a called program is being edited in background processing. Correct the program, or discontinue the background editing.

The subprogram was called in five folds. Modify the program.

Address P (program number) was not commanded in the block which includes an M98, G65, or G66 command. Modify the program.

An attempt was made to register a program whose number was protected.

The program number is other than 1 to 9999. Modify the program number.

The commanded program number has already been used. Change the program number or delete unnecessary programs and execute program registration again.