16i/18i/21i

DO -END does not correspond to 1 : 1. Modify the program.

Macro control command is used during DNC operation. Modify the program.

The macro modal call is specified four fold. Modify the program. The macro modal call is specified in double.
Modify the program.

The SQRT argument is negative. Or BCD argument is negative, and other values than 0 to 9 are present on each line of BIN argument. Modify the program.

The nesting of bracket exceeds the upper limit (quintuple). Modify the program.

The left side of substitution statement is a variable whose substitution is inhibited. Modify the program.

A value not defined as a variable number is designated in the custom macro or in high-speed cycle machining. The header contents are improper. This alarm is given in the following cases: High speed cycle machining 1. The header corresponding to the specified machining cycle number called is not found. 2. The cycle connection data value is out of the allowable range (0 -999). 3. The number of data in the header is out of the allowable range (0 -32767). 4. The start data variable number of executable format data is out of the allowable range (#20000 -#85535). 5. The last storing data variable number of executable format data is out of the allowable range (#85535). 6. The storing start data variable number of executable format data is overlapped with the variable number used in the header. Modify the program.

There is an error in the formats. Modify the program.

A function which cannot be used in custom macro is commanded. Modify the program.

Division by zero was specified. (including tan 90?) Modify the program.