16/18/21

P type cannot be specified when the program is restarted. (After the automatic operation was interrupted, the coordinate system setting operation was performed.) Perform the correct operation according to the operator

The commanded axis by G27 (Reference position return check) did not return to the reference position. Automatic reference position return (G28) or the commanded axis by
G27 (Reference position return check) did not return to the reference
position.

Manual reference position return cannot be performed when automatic operation is halted.

The reference position return cannot be performed normally because the reference position return start point is too close to the reference position or the speed is too slow. Separate the start point far enough from the reference position, or specify a sufficiently fast speed for reference position return. Check the program contents.

File data transfer via OSI-ETHERNET has been stopped due to a transfer error.

File data transfer via OSI-ETHERNET has been stopped due to a transfer error.

When entering data in the memory by using Reader / Puncher interface, though the read terminate command is specified, input is not interrupted after 10 characters read. I/O unit or P.C.B. is defective.

When entering data in the memory by using Reader / Puncher interface, the ready signal (DR) of reader / puncher was turned off. Power supply of I/O unit is off or cable is not connected or a P.C.B. is defective.

When entering data in the memory by using Reader / Puncher interface, an overrun, parity or framing error was generated. The number of bits of input data or setting of baud rate or specification No. of I/O unit is in correct.

In automatic tool length measurement or automatic tool compensation (G36, G37), an invalid axis was specified or the command is incremental. Modify the program.