0i

Other than P2, P3 and P4 are commanded for 2nd, 3rd and 4th reference position return command.

In canned cycle G73/G83, the depth of each cut (Q) is not specified. Alternatively, Q0 is specified. Correct the program.

One of G27 to G30 is commanded in canned cycle mode. Modify the program.

In the DRILL-MATE, a T code was not specified together with the M06
code in a block. Alternatively, the Tcode was out of range.

Tool offset (G45 to G48) is commanded in cutter compensation. Modify the program.

Overcutting will occur in cutter compensation C. Two or more blocks are consecutively specified in which functions such as the auxiliary function and dwell functions are performed without movement in the cutter compensation mode. Modify the program. Overcutting will occur in tool nose radius compensation. Modify the program. Overcutting will occur in tool nose radius compensation.
Modify the program.

Overcutting will occur in tool nose radius compensation in canned cycle G90 or G94. Modify the program.

Chamfering or corner R was specified with a start-up, a cancel, or switching between G41 and G42 in tool nose radius compensation. The program may cause overcutting to occur in chamfering or corner R. Modify the program.

Over cutting will occur in cutter compensation C or tool nose radius compensation because the arc start point or end point coincides with the arc center. Modify the program.

G40 is commanded on the plane other than offset plane in cutter compensation B. The plane selected by using G17, G18 or G19 is changed in cutter compensation C mode. Modify the program. The offset plane is switched in tool nose radius compensation. Modify the program.
The offset plane is switched in tool nose radius compensation.
Modify the program.