0i

Neither the end point nor angle is specified in the command for the block next to that for which only the angle is specified (A). In the chamfering command, I(K) is commanded for the X(Z) axis.

In the arbitrary angle chamfering or corner R block, the move distance is less than chamfer or corner R amount.

A block in which chamfering in the specified angle or the corner R was specified includes a taper command. Modify the program.

For systems without the arbitrary angle chamfering or corner R cutting, a comma was specified. For systems with this feature, a comma was followed by something other than R or C Correct the program. In the chamfering and corner R commands, two or more of I, K and R are specified. Otherwise, the character after a comma(

The block next to the chamfering or corner R block is not G01,G02 or G03.

Improper movement or the move distance was specified in the block next to the optional chamfering or corner R block. Modify the program. Improper movement or the move distance was specified in the block next to the chamfering or corner R block. Modify the program.

Optional chamfering or corner R is commanded in the thread cutting block. Modify the program. Chamfering or corner R is commanded in the thread cutting block. Modify the program.

The commands for three-dimensional coordinate conversion (G68,
G69) and tool length compensation (G43, G44, G45) are not nested.
Modify the program.

Start-up of three-dimensional tool compensation or three-dimensional coordinate conversion has been attempted, but the three basic axes used when Xp, Yp, or Zp is omitted are not set in parameter No. 1022.

Two or more parallel axes (in parallel with a basic axis) have been specified upon start-up of three-dimensional tool compensation or three dimensional coordinate conversion.