0i

The power turned off while rewriting the memory by program edit operation. If this alarm has occurred, press Reset while pressing Program key, and only the program being edited will be deleted. Register the deleted program.

On the PARAMETER (SETTING) screen, PWE (parameter writing enabled) is set to 1. Set it to 0, then reset the system.

After completion of search in program restart, a move command is given with MDI. Move axis before a move command or don

A command of the program restart was specified without the reference position return operation after power ON or emergency stop, and G28 was found during search. Perform the reference position return.

P type cannot be directed when the program is restarted. (After power ON, after emergency stop or P / S 94 to 97 reset, no automatic operation is performed.) Perform automatic operation.

P type cannot be specified when the program is restarted. (After the automatic operation was interrupted, the work piece offset amount changed.) Perform the correct operation according to the operator

P type cannot be specified when the program is restarted. (After the automatic operation was interrupted, the external work piece offset amount changed.) Perform the correct operation according to the operator

P type cannot be specified when the program is restarted. (After the automatic operation was interrupted, the coordinate system setting operation was performed.) Perform the correct operation according to the operator

The commanded axis by G27 (Reference position return check) did not return to the reference position. Automatic reference position return (G28) or the commanded axis by
G27 (Reference position return check) did not return to the reference
position.

Manual reference position return cannot be performed when automatic operation is halted.