0i

No decimal point has been specified for an address requiring a decimal point.

A radius exceeding nine digits has been specified for circular interpolation with the center of the arc specified with I, J, and K.

An erroneous parameter was specified for restarting a program. A parameter for program restart is invalid.

Function category: Polygon turning Alarm details: In G51.2 mode, the speed of the spindle or polygon synchronous axis either exceeds the clamp value or is too small. The specified rotation speed ratio thus cannot be maintained.

Transfer cannot be performed because no trace data exists.

The end of record (%) was specified. I/O is incorrect. modify the program.

A bus error occurred on the FANUC bus. The motherboard or option board may be faulty.

An NMI occurred as a result of an unknown cause.

An alarm condition occurred in the interface with an I/O unit. For PMC-
RA1, PMC-RA2, and PMC-RB, check that the PMC control module on
the main CPU board is conneted to the I/O unit securely. For PMC-RC,
check that the PMC control module on the option 3 board is connected
to the I/O unit is supplied with power and that the interface module is intact.

This is a sub-CPU error. Replace the sub-CPU PC board. The abnormal 24VDC input power may be defective.