MX2

NO AXIS COMMAND IN HIGH-SPEED CUTTING PROGRAM AT HIGH SPEED CUTTING COMMAND.

SPECIFIED AN EXCESSIVELY LARGE J IN THE WORK COORDINATE SYSTEM OR THE MODE WAS OTHER THAN G00/G01.

ENTERED COMMAND FOR T5 DIGITS ALTHOUGH ALL OF THE CONTENTS OF THE GROUP WERE IN SKP STATUS, OR ENTERED H(D)999 COMMAND WITHOUT REGISTERING TOOL NUMBERS H-no AND D-NO.

ENTERED COMMAND FOR T-5 DIGITS WITHOUT REGISTERING THE GROUP OR THERE IS AN ERROR IN THE T9999L AAA COMMAND. T9999L AAA COMMANDED ALTHOUGH THIS SETTING SHOULD BE COUNTED BY M20/M30.

TOOL LIFE CONTROL DATA COMMANDS EXCEEDED CAPACITY.

ERROR EXISTS IN SPECIFICATION OF P, I, T, L, H, AND D WITH COMMANDS G122/123.

AXIS OPERATED BY MDI AFTER PROGRAM RESTART.

COORDINATE SYSTEM CHANGED BY DEPRESSING THE CRT OPERATION CONTROL PANEL ORG KEY DURING PROGRAM RESTART.

G54 TO G59 COMMANDED THROUGH MDI OPERATION DURING PROGRAM RESTART.

G92 COMMANDED THROUGH MDI OPERATION DURING PROGRAM RESTART.