Yasnac

(1) R-POINT IN BACK BORING (2) Returns to R-point in G77 (back boring cycle)

(1) G70-G72 USED IN NON CANNED CYLCLE (2) G70-G72 was used in other than a canned cycle.

(1) UNUSABLE G CODE IN CYCLE (2) Command was for a G code unusable in a canned cycle.

(1) LACK OF ADDRESS (2) Requi red address specification is lacking.

(1) UNMATCH G CODE (2) Command is for a G code that cannot be used in combined form with one block.

(1) UNUSABLE G CODE (2) Command is for an option commanding an unusable G code.

(1) NO. H COMMAND (2) No command for offset number H.

(1) OFFSET NO. ERROR IN H/D. (2) Off set number during H/D changeover is too Iarge.

(1) MAX OFFSET NO. OVER (2) Offset number is too large.

(1) B CODE DIGITS OVER (2) More digits than permitted were specified for Code B.