Yasnac alarm: 328 - UNSUITABLE MM51 or MM21(MX3)
MEMORY LENGTH DOES NOT MATCH THE MEMORY BOARD.
Yasnac LX3 CNC machine control alarms and error codes for troubleshooting and repair of CNC's.
MEMORY LENGTH DOES NOT MATCH THE MEMORY BOARD.
MEMORY GENERATION IS NOT PERFORMED PROGRAM SPECIFIED BY 0, -999 MUST BE ERASED.
There was a servo-Off request from the ACGC 120 or AMGC.
SERVO CPU IS IN ABNORMAL STATE. (SET "O IN #6014 D6 TO RESET THE ERROR).
Synchronous error of ACGC CPU and NC Side CPU> (Set #6014D5 to 0 for release)
Synchronous error of ACGC 120 CPU and NC Side CPU> (Set #6014D5 to 0 for release)
THE UNUSED AREA OF THE CMOS IS USED. (THE CMOS MAY BE DESTROYED.) (SET "1" IN #6066 D2 TO RESET THE ERROR.)
SERVO POWER NOT SUPPLIED
Servo Drives are off. Condition exists that is not allowing a power on. Check drives for faults or Fault LEDS.
MACHINE NOT READY OR MACHINE READY OFF
P SET ERROR Z (IF THIS ERROR OCCURS IN BLOCK WHERE GOO IS CHANGING TO GO1, MACHINE STOPS AFTER COMPLETION OF GOO BLOCK)
Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer